The beneficiation equipment becomes a crushing device for ore high hardness materials. In the crushing of harsh and high hardness materials such as basalt, granite, diabase, limestone, etc., we should use mineral processing equipment to crush the material. The reason is that the hardness of the cracked material is low during the general production process, and the hardness of the material such as diabase is high and the degree of wear is large. The beneficiation equipment is a crushing device suitable for a variety of ores and rocks, with hardness and medium hardness.
The design of beneficiation equipment has novel design principles. It uses the new concept of crushing technology, which can meet the crushing of different material specifications, and meet the requirements of the new process of "multiple crushing and less grinding". The machine not only has a large crushing rate, but also has a fine granularity and low unit power consumption. The humidity of the crushed material is not high, and it is also suitable for crushing any hard and brittle materials. It can be used to crush various minerals. The machine has proved its good application prospect in the field of mineral processing through large-scale engineering. In addition, the cone crusher has a large output and high production capacity in the crushed material. The unique design of the machine greatly reduces the maintenance cost and maintenance cost of the machine, thereby greatly improving the production efficiency and production cost of the machine.
In sandstone production lines such as basalt, granite, diabase and limestone, wear parts such as slabs, hammers and counterattacks are very high. Therefore, in the design of the crushing process, the main crushing task uses the principle of lamination to reduce the wear of the wearing parts. Typical lamination equipment configurations are two-stage and cone crushing process configurations. Therefore, the beneficiation equipment also has high hardness materials. Wide range of applications.
After adjusting the discharge port of the beneficiation equipment, the size of the discharge port can be measured by a rotating method. Gently lift the adjustment ring, insert the beneficiation equipment into the crushing cavity for spraying, and precisely adjust the discharge port along the four relative positions around the circumference of the crushing cavity. When the adjusted discharge port meets the size requirements, the adjustment ring needs to be locked with the lock cylinder to start the cone crusher again.